Who does what
| Task | Who |
|---|---|
| Limits, load assumptions, references to standards | manufacturer |
| Structural calculations, evidence, product declarations | manufacturer and the specialists they appoint |
| Implementing and testing rules as data | configurator developer |
| Approving rules and maintaining them after changes | manufacturer |
| Final check in the individual case | manufacturer, dealer or designer, often after a site survey |
One example of the legal framework in Germany: under § 3 ProdSG, products subject to an ordinance under that act may only be made available on the market if they meet its requirements and do not endanger the safety and health of persons [1]. The requirement attaches to the product and to making it available, not to the software used to configure it. Which rules apply to your product is for your own specialists to establish. This is general information, not legal advice.
What it means for configurator wording
- A green check means "matches the stored rules", not "tested" or "approved".
- Standards are named only when the manufacturer specifies them and the source is known.
- Notes such as "structure is checked case by case" belong visibly in the summary and the enquiry.
- Limits carry a date and a version, so it stays clear what applied when.
In our example configurators
Every model in the library is an example configurator with a fictional product. Its dimensions, limits and rules are example values and make no statement about structure, safety, approval or standards. The calculation in the chemical store example is explicitly labelled as an example rule.
For your specification
Record who supplies the rules, who approves them and who maintains them after launch. See 3D configurators for manufacturers.